Materials Physics on an Atomistic Scale 2
Module version of SS 2015
There are historic module descriptions of this module. A module description is valid until replaced by a newer one.
Whether the module’s courses are offered during a specific semester is listed in the section Courses, Learning and Teaching Methods and Literature below.
|available module versions|
|SS 2021||SS 2020||SS 2019||SS 2018||SS 2017||SS 2015|
PH2219 is a semester module in German or English language at Master’s level which is offered in summer semester.
This Module is included in the following catalogues within the study programs in physics.
- Specific catalogue of special courses for condensed matter physics
- Specific catalogue of special courses for Applied and Engineering Physics
- Complementary catalogue of special courses for nuclear, particle, and astrophysics
- Complementary catalogue of special courses for Biophysics
If not stated otherwise for export to a non-physics program the student workload is given in the following table.
|Total workload||Contact hours||Credits (ECTS)|
|150 h||40 h||5 CP|
Responsible coordinator of the module PH2219 in the version of SS 2015 was Winfried Petry.
Content, Learning Outcome and Preconditions
This module is concerned with the arrangement and movement of atoms in solids. As these aspects determine to a large part the macroscopic properties of matter, their microscopical understanding is fundamental to, e.g., the tuning of materials for technological applications.
Going beyond the coverage of an introductory Solid State Physics course and continuing the course PH2218: Materials Physics on an Atomistic Scale 1, the following topics will be treated in detail:
- oscillations of atoms about their equilibrium positions -- phonons
- atoms exchanging places -- diffusive dynamics, jump mechanisms in elemental systems and ordered compounds, mass flux
- break-down of long-range order -- glasses, melts, and their dynamics
- transitions between different states of order -- dynamics and kinetics of phase transitions
For all the above points it is intended to give both a description of the physically observed phenomena and their motivation by microscopic models. Also, the relevant experimental techniques will be indicated and explained in principle, and, where applicable, simple computer models of the effects will be presented and provided to the students for tinkering with.
Upon successful completion of the module, students are able to
- understand the concept of phonons, their branches and symmetries over reciprocal space, densities of states and anharmonic effects
- describe the atomic-scale mechanisms of diffusion processes in elemental systems and ordered compounds
- understand the principles of quasi-elastic scattering methods
- use the concepts describing the non-crystalline state, such as pair distribution functions, and understand atomic dynamics specific to non-crystalline systems
- understand the types of phase transitions and order-order transitions
- predict the path through configuration space a given system takes under a change of external parameters in a qualitative way
- propose and justify experimental and/or theoretical methods to elucidate simple problems of atomic-scale materials science
No preconditions exceeding the admission requirements for the master degree program. Having participated in the course PH2218: Materials Physics on an Atomistic Scale 1 is beneficial, but no hard requirement.
Courses, Learning and Teaching Methods and Literature
Courses and Schedule
|VO||2||Materials Physics on an Atomistic Scale 2||Leitner, M.||
Wed, 10:00–12:00, PH-Cont. C.3201
Learning and Teaching Methods
Blackboard writing and verbal lecturing with active contributions from students (comprehension questions), occasional use of projector for diagrams, demonstrations of simple computer models (to be provided to the students for hands-on computer experimentation)
small program scripts to demonstrate simple models
Fundaments of solid-state physics:
- Neil W. Ashcroft, N. David Mermin: Solid State Physics
- H. Ibach, H. Lüth: Festkörperphysik
- Ch. Kittel: Introduction to Solid State Physics
- R. Gross, A. Marx: Festkörperphysik
- F. Schwabl: Statistische Mechanik
- G. Gottstein: Physikalische Grundlagen der Metallkunde
- P. Haasen: Physikalische Metallkunde
- D. A. Porter, K. E. Easterling: Transformations in Metals and Alloys
Description of exams and course work
In an oral exam the learning outcome is tested using comprehension questions and sample problems.
The exam may be repeated at the end of the semester.
Current exam dates
Currently TUMonline lists the following exam dates. In addition to the general information above please refer to the current information given during the course.
|Exam to Materials Physics on an Atomistic Scale 2|
|Mon, 2021-07-12||Dummy-Termin. Wenden Sie sich zur individuellen Terminvereinbarung an die/den Prüfer(in). Anmeldung für Prüfungstermin vor Mo, 27.09.2021. Melden Sie sich bitte nur an, wenn Sie die Prüfung verbindlich auch nach Lektüre der Informationen unter https://www.tum.de/die-tum/aktuelles/coronavirus/pruefungen/ ablegen werden. // Dummy date. Contact examiner for individual appointment. Registration for exam date before Mon, 2021-09-27. See https://www.tum.de/en/about-tum/news/coronavirus/coronavirus-exams/ for further information and only register after reading!||till 2021-06-30 (cancelation of registration till 2021-07-11)|
|Tue, 2021-09-28||Dummy-Termin. Wenden Sie sich zur individuellen Terminvereinbarung an die/den Prüfer(in). Anmeldung für Prüfungstermin zwischen Di, 28.09.2021 und Sa, 23.10.2021. Melden Sie sich bitte nur an, wenn Sie die Prüfung verbindlich auch nach Lektüre der Informationen unter https://www.tum.de/die-tum/aktuelles/coronavirus/pruefungen/ ablegen werden. // Dummy date. Contact examiner for individual appointment. Registration for exam date between Tue, 2021-09-28 and Sat, 2021-10-23. See https://www.tum.de/en/about-tum/news/coronavirus/coronavirus-exams/ for further information and only register after reading!||till 2021-09-27|